Classification of Coal Mills


Release date:

2021-07-06

  Low-speed coal mill

  The primary equipment is the drum-type steel-ball coal mill, commonly referred to as a ball mill. It consists of a rotating cylindrical drum, or a drum tapered at both ends, lined with steel balls. The drum rotates at 15–25 revolutions per minute. During operation, the steel balls inside continuously impact and compress the coal, grinding it into fine powder. Hot air introduced into the drum dries the coal and carries the pulverized fuel out; after separation by a classifier, the coal powder of the required particle size is either stored in a pulverized‑coal bunker or directly fed to the coal‑fired burner. Ball mills are heavy and bulky, consume substantial amounts of electricity, and generate considerable noise; however, they exhibit broad compatibility with various coal types, operate reliably, and are particularly well suited for grinding hard anthracite.

  Medium-speed coal mill

  The rotational speed ranges from 50 to 300 rpm, and there are many types. Common models include disc mills, bowl mills, E‑type mills, and roller mills (Figure 2). A shared characteristic of these mills is that their grinding elements consist of two sets of counter‑rotating grinding bodies. Coal lumps are crushed by being squeezed and ground between the surfaces of these two sets of grinding bodies. Meanwhile, hot air introduced into the mill dries the coal and carries the pulverized coal to a separator located above the grinding zone. After separation, coal powder of the desired particle size is carried out of the mill by the airflow, while coarser particles are returned to the grinding zone for re‑grinding. Medium‑speed coal mills offer significant advantages, such as compact equipment, a small footprint, lower power consumption (approximately 50–75% of that of ball mills), reduced noise, and relatively simple, responsive operational control; however…

  They have a more complex structure and manufacturing process, higher maintenance costs, and are not suitable for grinding harder coals. In large-capacity coal-fired boilers, bowl-type medium-speed mills are widely used.

  High-speed coal mill

  The rotational speed ranges from 500 to 1,500 rpm and the equipment primarily consists of a high-speed rotor and a grinding housing. Common types include fan mills and hammer mills. In a fan mill (Figure 3), coal particles are pulverized through high‑velocity impacts with the rotor, collisions against the mill housing, and mutual impacts among the particles themselves. This type of coal mill is integrated with a coal‑powder separator, featuring a simple, compact design and low initial capital cost, making it particularly suitable for grinding high‑moisture lignite and bituminous coals that are highly volatile and easy to grind. However, due to significant wear, fan mills have shorter continuous operating times than other coal mills and are not well suited for grinding hard coals.

Latest Updates

Copyright © 2026 Haixin Power Equipment Manufacturing (Nantong) Co., Ltd.

Business license