What are the technical standards for limestone powder used in flue gas desulfurization at power plants?


Release date:

2021-07-06

  Wet flue‑gas desulfurization technology is widely used in thermal power plants, accounting for approximately 90% of all desulfurization processes. Limestone, as the raw material, is readily available, low‑cost, and highly economical. However, the limestone powder employed in wet desulfurization must meet specific technical specifications.

  The finer the limestone powder, the faster the desulfurization reaction.

  Among the standard technical parameters, limestone powder used for desulfurization is required to have a particle size of 250 mesh or 325 mesh, with a sieve‑passing rate exceeding 95%; 325‑mesh limestone powder delivers superior desulfurization performance. The fineness of the limestone powder is a critical factor affecting desulfurization efficiency, as the reaction contact area largely determines the rate of the chemical reaction. The finer the particles, the greater the specific surface area per unit mass, and consequently the larger the contact area available for each unit mass of reactant, leading to a faster reaction rate and higher utilization. Conversely, if the particle diameter is too large, both the reaction rate and the utilization of the limestone will be reduced.

  The finer the limestone powder, the higher the purity of the desulfurization product—gypsum.

  In the limestone–gypsum flue-gas desulfurization process, limestone powder is mixed with water to form a slurry. At a given pH, the smaller the particle size of the limestone, the lower its calcium-to-sulfur ratio, and the desulfurization efficiency can exceed 95%.

  The finer the limestone, the lower the density of the absorber slurry; operating at a lower density is more efficient, and the resulting lime is purer. The limestone slurry density should be kept below 1,300 kg/m³ (excessively high slurry density can hinder limestone dissolution and slow down the reaction rate, leading to an excessive carryover of residual limestone in the gypsum slurry during dewatering; a lower density also facilitates smoother opening and closing of the slurry supply valves, reducing control lag).

Latest Updates

Copyright © 2026 Haixin Power Equipment Manufacturing (Nantong) Co., Ltd.

Business license